Zhongshan Aoba Chemical Co

The printing of real inorganic diatom mud is screen mold printing, which is to make the flower pattern you choose into a fixed mold. Then the diatom mud is also purely natural and not chemically blended. It has no toxic side effects, is healthy and environmentally friendly, Use such a mold and diatom mud to print exquisite patterns in suitable proportions on the walls of your home. The following will introduce to you the printing process flow of Aoba
diatom mud manufacturer
.
Use tools such as trowel, pallet, scraper, ash knife, knife, crochet hook, infrared level, screen mold, etc.
Required tools

Plan according to the size of the wall. To facilitate construction, necessary marks can be made on the wall before construction.
Stirring: Add the amount of construction water into the mixing container, then pour in the Oba diatom mud dry powder and soak it for a few minutes, then use an electric mixer to stir for about a minute, while stirring, use additional water to adjust the construction viscosity. For mud paint, stir it thoroughly before use.
Level measurement
Apply twice. The first coat should be leveled about millimeters and about 10 minutes after completion (depending on the on-site climate conditions, the surface should not stick to your hands. If the bottom is exposed, use material to make up the level) , apply a second coat (thickness about mm). The total thickness is between millimeters and millimeters. The two-pass coating process is the same as the batch coating process, and does not require a flat light. After it is semi-dry (it will take about an hour), sand it with sandpaper and use a dry towel to remove any floating dust. At this time, two people are needed to assist. The printing material is made of fine diatom mud to avoid damaging the template and make the printed effect more delicate.
Screen printing process construction

When doing screen printing, you need to use a level to measure straight and vertical lines. At this time, the lighting effect needs to be very bright. Some wall yin and yang angles are not right angles. Before starting, you must use a level to calibrate the wall printing position. Only during construction can the offset angle be controlled within a reasonable range, so that the overall beauty is difficult to distinguish with the naked eye. The technical requirements for the molding personnel will be relatively high, requiring that the stitching deviation of each plate be controlled within a certain range, so that the overall aesthetics will be coordinated. Another one should use a scraper immediately after the template is aligned. It is best to scrape along the same direction. , and each mesh should not be scraped more than three times. This can reduce mesh blockage and make the texture more realistic. After scraping one template, start the construction of the second template immediately, and finally use a soft mold to perform the same operation on the yin and yang corners. .
Screen cleaning

. Precautions: The thickness of the screen printing is about millimeters. When constructing the combined screen mold, it must be carried out according to the alignment points on the screen printing mold. The mold needs to be tightly attached to prevent mud from seeping along the edge seams. When removing the mold after screen printing (you do not need to wait for the material to dry), you should avoid damaging the corners of the pattern with the screen mold. Fix one side first and slowly pick up the mold from the other side. Screen printing molds need to be cleaned frequently. Cleaned screen printing molds must be completely dry before use again, otherwise the moisture on the mold will stain the wall.
Tea Ceremony Printed Pattern